PTZ Disassembly 
Tha's what it should look like when you put the top base back on. Remember - do NOT OVERTIGHTEN THE SCREWS! Otherwise you will break it again...
Tha's what it should look like when you put the top base back on. Remember - do NOT OVERTIGHTEN THE SCREWS! Otherwise you will break it again...
Viewed: 1269 times.

Next, put the bottom body back in. Again, ensure that the flat cable is pulled out through the hole as seen in the photo.
Next, put the bottom body back in. Again, ensure that the flat cable is pulled out through the hole as seen in the photo.
Viewed: 1243 times.

Next, put the camera back in and once again, ensure that you put the flat cable through the hole.
Next, put the camera back in and once again, ensure that you put the flat cable through the hole.
Viewed: 1186 times.

If you like, you can remove the front glass/plastic out to clean it. Mine was full of fingerprints!  Put it back in when done.
If you like, you can remove the front glass/plastic out to clean it. Mine was full of fingerprints! Put it back in when done.
Viewed: 1229 times.

Put all of the screws back in. Silver first and then black screws.
Put all of the screws back in. Silver first and then black screws.
Viewed: 1236 times.

Put the flat cable back in the white plastic clip.
Put the flat cable back in the white plastic clip.
Viewed: 1187 times.

That's what it looks like when you put the clip back on.
That's what it looks like when you put the clip back on.
Viewed: 1221 times.

Finally, put the top body on. Remember to align the front glass/plastick with the grooves.
Finally, put the top body on. Remember to align the front glass/plastick with the grooves.
Viewed: 1248 times.

Turn the camera round, screw them in (again, do not overtighten)
Turn the camera round, screw them in (again, do not overtighten)
Viewed: 1330 times.

Powered by Gallery v1
Home Home Home Home Home