Hello there! I am going to show you how to disassemble the PTZ-2 camera so you can do whatever work on it. In these steps, I am going to show you how to fix the tilting problem, which is a common problem with all PTZ-2P cameras. This was caused by a broken casting which holds the camera in place. You would hear it making a "clicking" noise when you tried to get the camera down. So without any delay, let?s get started!
Viewed: 1096 times.
|
Turn the camera round. You should see three holes. In this photo, you should see two holes. That's where you can unscrew the screws. You will need an 'X' head screwdriver
Viewed: 1094 times.
|
At the back of the camera, you should see another hole.
Viewed: 1062 times.
|
The screws. In case you got the screws mixed up, here's what they look like.
Viewed: 1011 times.
|
Turn the camera round. You should be able to take the top body off easily.
Viewed: 1136 times.
|
Top view of the camera
Viewed: 1174 times.
|
Close up. You should see four black screws. That's to hold the bottom body together. You should also see four silver (smaller) screws. That holds the camera with the bottom movement part.
Viewed: 1110 times.
|
Remove the black screws first. That will "loosen" the bottom body.
Viewed: 1114 times.
|
Then remove the silver screws and it will loosen the camera.
Viewed: 1059 times.
|
